Troubleshooting
Phaser 3610, WorkCentre 3615 Service Manual2-178
FIP 1. 118
026-721 USB Memory Write Error
Cause:
Writing to USB memory failed.
Solution:
The machine will recover after the OK or Close button is pressed or message is displayed for
specified time.
If the error persists:
1. Change the USB Memory that satisfies the specification.
2. Ensure that the error is replicated after the printer is powered Off and then On, and then
replace the following parts in sequence.
•(REP 5.5 Front USB PWB)
•(REP 5.1 ESS PWB)
FIP 1. 119
027-446 IPv6 Duplicate
Cause:
At start-up, detect duplicate IPv6 address on network.
Solution:
1. Duplicate IPv6 addresses have been detected. Contact the system administrator.
2. Remove duplicates and then power off the printer and then on.Take corrective actions at the
host side.
FIP 1. 120
027-452 IPv4 duplicate
Cause:
At start-up, detect duplicate IPv4 address on network.
Solution:
1. Duplicate IPv4 addresses have been detected. Contact the system administrator.
2. Remove duplicates and then power off the printer and then on. Take corrective actions at the
host side.