Xerox WorkCentre 3615 Service Manual

Troubleshooting
Phaser 3610, WorkCentre 3615 Service Manual2-184
FIP 1. 131
031-531 Couldn't get file/folder name of SMB scan server
Cause:
Couldn't get file/folder name of server.
Solution:
The machine will recover after the OK or Close button is pressed or message is displayed for
specified time.
If the error persists:
1. Check access right of the folder you specified.
2. Perform the following in sequence.
• " Network System Fault Check"
• " Network-related Details Check Flow"
3. Ensure that the error is replicated after the printer is powered Off and then On, and then
replace (REP 5.1 ESS PWB).
FIP 1. 132
031-532 Suffix of SMB scan file name/folder name is over limit
Cause:
Suffix of file name/folder name is over limit.
Solution:
The machine will recover after the OK or Close button is pressed or message is displayed for
specified time.
If the error persists:
1. Change file name/forwarding destination folder, or move or delete file in forwarding
destination folder.
2. Perform the following in sequence.
• " Network System Fault Check"
• " Network-related Details Check Flow"
3. Take corrective actions at the host side.

Xerox WorkCentre 3615 Specifications

General

Print Technology	Laser
Print Resolution	Up to 1200 x 1200 dpi
Fax	Yes
Duplex Printing	Yes
Functions	Print, Copy, Scan, Fax
Processor	533 MHz
Memory (Standard)	256 MB
Paper Output	250 sheets
Fax Speed	33.6 kbps
Print Speed	47 ppm
Scan Resolution	600 x 600 dpi
Automatic Document Feeder	50 sheets
Connectivity	Ethernet
First Page Out Time (Copy)	8.5 seconds
Paper Capacity	250 sheets
Network Connectivity	Ethernet
Operating System Compatibility	Windows, Mac, Linux