Xerox WorkCentre 3615 Service Manual

Troubleshooting
Phaser 3610, WorkCentre 3615 Service Manual 2-251
FIP 1. 259
050-132 IOT Remain Zone Regi + MSI + T1 + T2 Jam
050-132 is displayed in the UI. 077-106 is registered in the Error Log.
Cause:
When Dynamic Jam (cause) was detected:
• 077-106 Exit On Jam
When Static Jam (collateral) was detected:
•Regi Sensor On
Solution:
1. Paper jam has occurred. Remove the jammed paper.
2. If there is no jammed paper, or the error still occurs after having removed the jammed paper,
turn the power Off and On to check that the error recurs, then proceed to the
FIP 1. 284.
FIP 1. 260
050-134 IOT Zone MSI + T1 Jam
051-134 is displayed in the UI. Either of the following error codes is registered in the Error Log.
• 071-100 IOT Tray1 Misfeed Jam
• 075-100 MSI Misfeed Jam
Cause:
When Dynamic Jam (cause) was detected:
• 071-100 IOT Tray1 Misfeed Jam
• 075-100 MSI Misfeed Jam
Solution:
1. Paper jam has occurred. Remove the jammed paper.
2. If there is no jammed paper, or the error still occurs after having removed the jammed paper,
turn the power Off and On to check that the error recurs, then proceed to the FIP.
• 071-100 IOT Tray1 Misfeed Jam, go to FIP 1. 273.
• 075-100 MSI Misfeed Jam, go to FIP 1. 281.

Xerox WorkCentre 3615 Specifications

General

Print Technology	Laser
Print Resolution	Up to 1200 x 1200 dpi
Fax	Yes
Duplex Printing	Yes
Functions	Print, Copy, Scan, Fax
Processor	533 MHz
Memory (Standard)	256 MB
Paper Output	250 sheets
Fax Speed	33.6 kbps
Print Speed	47 ppm
Scan Resolution	600 x 600 dpi
Automatic Document Feeder	50 sheets
Connectivity	Ethernet
First Page Out Time (Copy)	8.5 seconds
Paper Capacity	250 sheets
Network Connectivity	Ethernet
Operating System Compatibility	Windows, Mac, Linux