Xerox WorkCentre 3615 Service Manual

Troubleshooting
Phaser 3610, WorkCentre 3615 Service Manual 2-321
FIP 2.08
Exit Clutch Assembly
Cause:
Parts to be considered:
• DRIVE EXIT OUT HOLDER ASSEMBLY (PL 4.1 Drive)
• DRIVE EXIT IN HOLDER ASSEMBLY (PL 4.1 Drive)
•EXIT CLUTCH ASSEMBLY (PL 4.1 Drive)
•MCU PWB (PL 5.3 Electrical (MCU PWB / HVPS))
Solution:
Step Check and Action Yes No
1
Are there any foreign substances in the EXIT
CLUTCH ASSEMBLY Drive Section?
Remove the foreign
substances
Go to Step 2.
2
Is the DRIVE EXIT OUT HOLDER ASSEMBLY
or the DRIVE EXIT IN HOLDER ASSEMBLY
damaged?
Replace the DRIVE
EXIT OUT HOLDER
ASSEMBLY and the
DRIVE EXIT IN
HOLDER ASSEMBLY
Go to Step 3.
3
Check the connection between the CLUTCH
ASSEMBLY EXIT and the MCU PWB.
• Is the EXIT CLUTCH ASSEMBLY (P/J16)
connected securely?
Go to Step 4.
Securely connect
the CLUTCH
ASSEMBLY EXIT
4
• Replace the EXIT CLUTCH ASSEMBLY.
Does an error occur?
Replace
(REP 5.6 MCU PWB)
Troubleshooting
complete.

Xerox WorkCentre 3615 Specifications

General

Print Technology	Laser
Print Resolution	Up to 1200 x 1200 dpi
Fax	Yes
Duplex Printing	Yes
Functions	Print, Copy, Scan, Fax
Processor	533 MHz
Memory (Standard)	256 MB
Paper Output	250 sheets
Fax Speed	33.6 kbps
Print Speed	47 ppm
Scan Resolution	600 x 600 dpi
Automatic Document Feeder	50 sheets
Connectivity	Ethernet
First Page Out Time (Copy)	8.5 seconds
Paper Capacity	250 sheets
Network Connectivity	Ethernet
Operating System Compatibility	Windows, Mac, Linux