EasyManuals Logo

Xerox WorkCentre 3615 Service Manual

Xerox WorkCentre 3615
774 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #60 background imageLoading...
Page #60 background image
Troubleshooting
Phaser 3610, WorkCentre 3615 Service Manual2-2
Introduction
This chapter describes error messages displayed on the Control Panel or listed on the Error History
page, Service Diagnostics used to test system operation and troubleshooting procedures to correct
problems.
Flow of Troubleshooting
The fault repair operation proceeds in the following flow:
Check Installation Status
Check the Problem Status
Perform FIP
Check if the fault is repaired
End
General
Wiring Data
Principle of Operation
Reference
Information

Table of Contents

Other manuals for Xerox WorkCentre 3615

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox WorkCentre 3615 and is the answer not in the manual?

Xerox WorkCentre 3615 Specifications

General IconGeneral
Print TechnologyLaser
Print ResolutionUp to 1200 x 1200 dpi
FaxYes
Duplex PrintingYes
FunctionsPrint, Copy, Scan, Fax
Processor533 MHz
Memory (Standard)256 MB
Paper Output250 sheets
Fax Speed33.6 kbps
Print Speed47 ppm
Scan Resolution600 x 600 dpi
Automatic Document Feeder50 sheets
ConnectivityEthernet
First Page Out Time (Copy)8.5 seconds
Paper Capacity250 sheets
Network ConnectivityEthernet
Operating System CompatibilityWindows, Mac, Linux

Related product manuals