Specifications
Phaser 3610, WorkCentre 3615 Service Manual8-30
DADF
Acceptable Document
Feed-able paper size:
• Min: Fast scan direction 5.5 in. (139.7mm) x Slow scan direction 5.5 in. (139.7mm)
• Max: Fast scan direction 8.5 in. (215.9mm) x Slow scan direction 14 in. (355.6mm)
Basis weight:
• Simplex:50g/m2 - 125g/m2
• Duplex: 60gm2 - 125g/m2
Paper type:
• Cut paper, plain paper
Irregular Document
The documents shown below shall not be damaged (torn) when they are fed from the DADF. However,
image quality, jam rate, etc. are not guaranteed.
• Thermal paper.
• Documents with smooth surface (coating paper).
• Documents with rough surface.
• Documents immediately after printed out.
• Documents with many punch holes (Loose-leaf paper, etc.).
• Unfolded half/Z-folded documents.
• Hole-punched documents.
Prohibited Document
It is prohibited to feed the following documents from the DADF.
• Stapled or clipped documents.
• Documents with paper, tape, etc. attached on it.
• Torn documents.
• Special documents other than documents that are specified as not guaranteed in this
performance specification.
•Photos.
• Transparencies.
• Documents with silicon etc. adhered to it.
• Documents that are curled by 0.4 in. (10mm) or more in height, and the height/length (h/l)
ratio is 1/4 or more (See the figure below).
• Documents folded by 0.2 in. (5mm) or more in height and 0.8 in. (20mm) or less in length
• Documents of which basis weight is less than 50g/m2 or more than 125g/m2.
• Documents that meet more than one condition defined in this performance specification for
document not guaranteed.
To Next Page
Loading...
Need help?
General
