Specifications
Phaser 3610, WorkCentre 3615 Service Manual 8-35
Grain Direction
Grain refers to the alignment of paper fibers in a sheet of paper. Grain is either long, running the
length of the paper, or short, running the width of the paper. For 60 to 135 g/m² (16 to 36 lb. bond)
paper, long grain fibers are recommended. For papers heavier than 135 g/m² (36 lb. bond), short grain
is preferred.
Fiber Content
Most high-quality xerographic paper is made from 100% chemically pulped wood. Paper containing
fibers such as cotton possess characteristics that can result in degraded paper handling.
Recommended Paper
Refer to the Recommended Media List (RML) for media approved for use in this product.
Unacceptable Paper
The following paper types are not recommended:
• Chemically treated papers used to make copies without carbon paper, also known as
carbonless papers, carbonless copy paper (CCP), or no carbon required (NCR) paper
• Preprinted papers with chemicals affected by Fuser temperatures
• Preprinted forms that require registration (the print location on the page) greater than ±0.09
in., such as optical character recognition (OCR) forms. In some cases, the application can
adjust registration to successfully print on these forms.
• Coated papers (erasable bond), synthetic papers, thermal papers
• Rough-edged, rough or heavily textured surface papers or curled papers
• Recycled papers containing more than 25% post-consumer waste that do not meet DIN 19
309
• Multiple-part forms or documents
• Perforated or pre-cut label paper
To Next Page
Loading...
Need help?
General
