ABB AC500 V3 - Page 29

Terminal Signal Description
11 NO2 Normally-open relay contact of the output NO2
12 NO3 Normally-open relay contact of the output NO3
13 R2..3 Output common for signals NO2 to NO3
Table 12: Assignment of the terminals for PM5032-T-ETH, PM5052-T-ETH and PM5072-
T-2ETH(W):
Terminal Signal Description
1 COM 0..11 Input common for digital input signals I0 to I11
2 I0 Digital input signal I0 (max. 5 kHz)
3 I1 Digital input signal I1 (max. 5 kHz)
4 I2 Digital input signal I2 (max. 5 kHz)
5 I3 Digital input signal I3 (max. 5 kHz)
6 I4 Digital input signal I4
Forward counter (max. 100 kHz), Encoder (max. 200
kHz)
7 I5 Digital input signal I5 (100 kHz)
Forward counter (max. 100 kHz), Encoder (max. 200
kHz)
8 I6 Digital input signal I6 (100 kHz)
Forward counter (max. 100 kHz), Encoder (max. 200
kHz)
9 I7 Digital input signal I7 (100 kHz)
Forward counter (max. 100 kHz), Encoder (max. 200
kHz)
10 I8 Digital input signal I8
11 I9 Digital input signal I9
12 I10 Digital input signal I10
13 I11 Digital input signal I11
14 O0 Digital output signal O0 (max. 5 kHz)
15 O1 Digital output signal O1 (max. 5 kHz)
16 O2 Digital output signal O2 (max. 5 kHz)
17 O3 Digital output signal O3 (max. 5 kHz)
18 O4 Digital output signal O4
PWM (max. 100 kHz), PTO (max. 200 kHz)
19 O5 Digital output signal O5
PWM (max. 100 kHz), PTO (max. 200 kHz)
20 O6 Digital output signal O6
PWM (max. 100 kHz), PTO (max. 200 kHz)
21 O7 Digital output signal O7
PWM (max. 100 kHz), PTO (max. 200 kHz)
22 C12 Digital input/output signal configurable C12
23 C13 Digital input/output signal configurable C13
Device specifications
Processor modules > AC500-eCo
2022/01/31 3ADR010278, 3, en_US 29