DISPlay Subsystem 5
N1911A/1912A P-Series Power Meters Programming Guide 227
Reset Condition
On reset, the value is set to –70 dBm for both windows.
Query
DISPlay:[WINDow[1]|2]:ANALog:LOW? [MIN|MAX]
The query returns the current setting of the analog meter’s lower scale
limit, or the value associated with MIN or MAX. The format of the response
is <NR3>. The units in which the results are returned are determined by
the current setting of UNIT:POWer and CALCulate:RELative:STATe as
shown in Table 5- 15.
Query Example
DISP:WIND1:ANAL:LOW? This command queries the lower scale
limit set on the analog meter in the upper
window.
To Next Page
Loading...
