10 SENSe Subsystem
368 N1911A/1912A P-Series Power Meters Programming Guide
The query enters a 1 or 0 into the output buffer indicating whether
automatic filter length is enabled or disabled.
• 1 is returned when automatic filter length is enabled
• 0 is returned when automatic filter length is disabled
Query Example
Error Messages
If [SENSe[1]]|SENSe2:AVERage:COUNt:AUTO is set to ON while
[SENSe[1]]|SENSe2:SPEed is set to 200, the error –221, “Settings
Conflict” occurs. However, automatic averaging is enabled but the
[SENSe[1]]|SENSe2:AVERage:STATe command is not automatically set ON.
AVER:COUN:AUTO? This command queries whether automatic
filter length selection is on or off for
Channel A.
To Next Page
Loading...
