12 SYSTem Subsystem
532 N1911A/1912A P-Series Power Meters Programming Guide
TRIG[:SEQ]:DEL 0 Delay between recognition of trigger
event and start of a measurement
TRIG[:SEQ]:HOLD 1 µs Trigger holdoff
TRIG[:SEQ]:HYST 0 dB Fall/rise below/above TRIG:LEV
TRIG[:SEQ]:LEV 0 dB Power level
TRIG[:SEQ]:LEV:AUTO ON Enable automatic setting of trigger
level
TRIG[:SEQ]:SLOP POS Trigger event recognized on rising
edge
TRIG[:SEQ[1]|2]:COUN 1 Trigger events for measurement
cycle
TRIG[:SEQ[1]|2]:DEL:AUTO ON Enable settling time delay
TRIG[:SEQ[1]|2]:SOUR IMM Trigger source set up
UNIT:POW dBm Power units
UNIT:POW:RAT dB Ratio units
Command Setting Comments
To Next Page
Loading...
Need help?
General
