Save your work
1 Choose File > Save As to save the current scene.
2 Save your work in the wire directory of the Lessons project.
3 Name your file myvacuum4.wire.
Part 5: Air Vents
In this section, you will create grooves to represent styled air intakes.
Opening the tutorial file (optional)
If you successfully completed Part 4, you can proceed directly to the next step,
Creating the groove surfaces.
If you were not successful in part 4, open the file called vacuum_part5.wire,
located in the wire directory of the CourseWare project. This file contains the
completed model from Part 4.
Watch Part 5 of the tutorial.
334 | Chapter 6 Modeling a Vacuum Cleaner
To Next Page
Loading...