Save your work
1 Choose File > Save As to save the current scene.
2 Save your work in the wire directory of the Lessons project.
3 Name your file myvacuum7.wire.
Part 8: Completing the Model
In this section, you will complete the model by mirroring the surfaces. You
also have the option of creating the power cable to finish off the presentation
of the design.
Opening the tutorial file (optional)
If you successfully completed Part 7, you can proceed directly to the next step,
Mirroring the surfaces.
If you were not successful in part 7, open the file called vacuum_part8.wire,
located in the wire directory of the CourseWare project. This file contains the
completed model from Part 7.
Part 8: Completing the Model | 385
To Next Page
Loading...