Save your work
1 Choose File > Save As to save the current scene.
2 Save your work in the wire directory of the Lessons project.
3 Name your file myvacuum5.wire.
Part 6: Power Button
In this section, you will create the on/off button for the vacuum cleaner.
You will create the button detail in two stages. First, you will create a recess
in the body surface where the button will sit. Then, you will create the button
so it sits flush with the body surface.
Because one set of surfaces will fit into another, you will use layers to organize
the geometry.
Opening the tutorial file (optional)
If you successfully completed Part 5, you can proceed directly to the next step,
Creating a cylinder for the power button.
Part 6: Power Button | 347
To Next Page
Loading...