Autodesk ALIAS 2010 - Creating the Front Surface

Finally, you will duplicate the front casing to create the rear casing, and
organize all the geometry onto layers.
Opening the tutorial file (optional)
If you successfully completed Part 2, proceed to the next step: Creating the
Front Surface, below.
If you were not successful in part 2, open the file called MP3Player_Part3.wire,
located in the wire directory of the CourseWare project. This file contains the
completed model from Part 2.
Watch Part 3 of the tutorial.
Creating the Front Surface
First you will create the front face of the casing, and position it at the correct
height for the MP3 Player dimensions.
1 Maximize the Top window.
426 | Chapter 7 Modeling an MP3 Player