■ create a granite texture
■ create a bulge texture
■ delete a texture
■ raytrace a scene
■ adjust surface reflectivity
Part 1: Editing the Render Globals parameters
In this section, you will adjust the Render Globals parameters to improve
the quality of the rendered image. Then, you will render the scene again, and
save your work.
You will begin by re-rendering the scene from the last tutorial.
Watch Part 1 of the tutorial.
Opening the tutorial file
1 Choose File > Open to open the File Browser.
2 In the File Browser, locate the CourseWare directory and set it as the
Current Project.
3 Open the file called more_rend.wire, located in the wire file of the
CourseWare directory.
For information on how to open a file, see Opening the tutorial file on
page 82.
684 | Chapter 11 More rendering
To Next Page
Loading...