■ (b) Use Transform > Rotate
■ (c) In the Layer tab, use the symmetry setting.
■ (d) Use the symmetry setting in the Control Panel
■ (e) Use the Symmetry setting in each surface tool
4 How many CVs does a single-span, degree 2 curve have?
■ (a) one
■ (b) two
■ (c) three
■ (d) four
■ (e) five
5 What kind of continuity does the Round surface produce?
■ (a) You can choose either Tangent or Curvature
■ (b) None
■ (c) Positional only
■ (d) Tangent only
■ (e) Curvature only
6 What is important when calculating the volume of a model?
■ (a) The surfaces represent a closed volume
■ (b) The surfaces all face outwards
■ (c) There are no duplicate surfaces
■ (d) Which units are set up in the Construction options
■ (e) All of the above
Quiz | 601
To Next Page
Loading...