Digi IX20

Hotspot
IX20 User Guide
378
4. Change the default maximum upload speed:
(config)> network hotspot hotspot bandwidth_max_up value
(config)>
where value is an integer between 1and 100000 and represents the maximum upload speed in
Kbps.
Note Setting the maximum upload speed to 0 meansthat the bandwidth is unlimited. Thiscan
havean adverse effect on performance.
5. Save the configuration and apply the change
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Add an Ethernet port to the default hotspot
Required configuration items
n
Enable default hotspot configuration. See Enable hotspot using the default configuration for
instructions.
n
Ethernet port to beadded to the hotspot.
To add an Ethernet port to the default hotspot:
 Web
1. Log into Digi Remote Manager, or log into the local Web UI asa user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI: