To Next Page

To Previous Page

Hotspot

IX20 User Guide

392

10. (Optional) If local is selected for login, set the name of the local HTML file used for

authentication. (This option is not available if auth is set to hotspotsystem.)

(config network hotspot new_hotspot)> local_page HTML_filename

(config network hotspot new_hotspot)>

Normally, this parameter should beleft blank, and the device will use the default

authentication HTML page. See Hotspot authentication modesfor information about the

default authentication HTML page used for each authentication mode.

If you upload a custom HTML file that uses a filename other than the default filename, type the

custom filename here. See Upload custom hotspot HTML pages for more information about

creating and uploading custom HTML files.

11. (Optional) Set the port number that the hotspot authentication server will used.

(config network hotspot new_hotspot)> auth_port port

(config network hotspot new_hotspot)>

The default is 3990.

12. (Optional) Set the port number of the hotspot server.

(config network hotspot new_hotspot)> server_port port

(config network hotspot new_hotspot)>

The default is 4990.

13. If remote is selected for login:

a. Set the IPaddressor fully-qualified domain name or the remote web server that will be

used for client authentication:

(config network hotspot new_hotspot)> remote url address

(config network hotspot new_hotspot)>

a. (Optional) Set the shared secret that the remote server and the hotspot. Used with cloud-

based hotspot providers.

(config network hotspot new_hotspot)> remote secret secret

(config network hotspot new_hotspot)>

14. (Optional) Change the default DHCPserver configuration.

Note The hotspot DHCPserver isautomatically enabled and cannot be disabled.

a. Set the amount of time that a client DHCPlease is valid:

(config network hotspot new_hotspot)> ipv4 address dhcp_server lease_

time value

(config network hotspot new_hotspot)>

where value is any number of weeks, days, hours, minutes, or seconds, and takes the

format number{w|d|h|m|s}.

For example, to set lease_time to ten minutes, enter either 10m or 600s:

Digi IX20 User Manual

Questions and Answers: