Dräger Zeus Infinity Empowered - Setting Autoset Limits for the Anesth.; Ventilation Area; Setting Autoset Limits for the Hemodyn. Area; Setting Autoset Limits for the IBP Area

Instructions for use Zeus Infinity Empowered SW 2.n 173
Alarms
Setting Autoset limits for the Hemodyn.
area
z Touch the Hemodyn. tab (A).
The following parameters can be configured:
B HR (heart rate)
C SpO
2 (blood oxygen saturation)
D NIBP S (systolic blood pressure)
E NIBP D (diastolic blood pressure)
F NIBP M (mean blood pressure)
G T1 (temperature, measuring point 1)
H T2 (temperature, measuring point 2)
I TBlood (blood temperature, monitored for C.O.
measurement)
Setting Autoset limits for the IBP area
z Touch the IBP tab (A).
The following parameters can be configured:
B ART S, ART D, ART M (artery blood pressure
values)
C PA S, PA D, PA M (pulmonary arterial blood
pressure values)
D CVP M (mean central venous pressure)
E GP1 S, GP1 D, GP1 M (non-specific (general
pressure) blood pressure values)
F LV S, LV D, LV M (left ventricular blood pres-
sure values)
G RV S, RV D, RV M (right ventricular blood pres-
sure values)
H LA M (mean pressure for left atrium)
I RA M (mean pressure for right atrium)
J GP2 S, GP2 D, GP2 M (non-specific (general
pressure) blood pressure values)
K ICP M (me
an pressure
for intracranial blood
pressure)
Setting Autoset limits for the Anesth./
Ventilation area
z Touch the Anesth./ Ventilation tab (A).
The following parameters can be configured:
B inN2O (inspiratory N2O content of the breathed
air)
C inHal, inEnf, inIso, inSev, inDes (inspiratory
anesthetic agent concentration)
D etCO
2 (expiratory CO2 content)
E MVe (expiratory minute volume)
F Paw (airway pressure)
371372
Alarms
A
BCD
E
F
GH
I
Alarms
A
B
C
D
E
F
GH
I
J
K
373
Alarms
A
B
C
D
E
F