Dräger Zeus Infinity Empowered - Rear with Doors Open

Instructions for use Zeus Infinity Empowered SW 2.n 27
Overview
Without optional patient monitoring, only the con-
nection to the optional IV system is installed.
Rear with doors open
A Mount for cylinder pressure reducer
B Gas supply block
C Backup gas cylinders with pressure reducers
D Waste gas connector
E 3 ports for DrägerService (behind the left-hand
backup gas cylinder and above the AGS)
F Anesthetic gas receiving system (AGS)
G Auxiliary power sockets
H Circuit breaker
Use only in an emergency to interrupt battery
charging and to switch off the device with the
exception of the screen. To disconnect the en-
tire device from the power supply, unplug the
mains plug.
I Electrical connections for cylinder pressure
sensors
010
MULTIMED Connection for accessories to
measure oxygen saturation
(SpO
2), electrocardiography
(ECG HR/PLS), and body temper-
ature (Temp)
HEMOMED 1 Connection for accessories to
measure invasive blood pressures
(IBP) and cardiac output (C.O.)
Aux/Hemo 2/3 Connection for accessories to
measure more invasive blood pres-
sures (More IBP) and cardiac out-
put (C.O./ Calculat.)
Connection for anesthesia effect
monitoring accessories (Trident
pod, BISx pod)
NIBP Connection for accessories to
measure non-invasive blood pres-
sure (NIBP)
Sync. Connection for synchronization of
a defibrillator
IV system Connection for Dräger IV system
(IVenus)
NIBP
Aux / Hemo 2 Aux / Hemo 3
HEMOMED 1
MULTIMED
IV-System
Sync.
173
A
B
C
D
F
G
H
I
E
E
E