Lenze i550

Address Name / seng range / [default seng] Info
11 Setpoint preset 1 Display of the setpoint source that is currently acve.
12 Setpoint preset 2
13 Setpoint preset 3
14 Setpoint preset 4
15 Setpoint preset 5
16 Setpoint preset 6
17 Setpoint preset 7
18 Setpoint preset 8
19 Setpoint preset 9
20 Setpoint preset 10
21 Setpoint preset 11
22 Setpoint preset 12
23 Setpoint preset 13
24 Setpoint preset 14
25 Setpoint preset 15
31 Segment preset 1
32 Segment preset 2
33 Segment preset 3
34 Segment preset 4
35 Segment preset 5
36 Segment preset 6
37 Segment preset 7
38 Segment preset 8
39 Last segment
50 Motor potenometer
51 PID setpoint (from version 04.00)
201 Internal value (from version 05.00)
202 Internal value (from version 05.00)
203 Internal value (from version 05.00)
204 Internal value (from version 05.00)
205 Internal value (from version 05.00)
206 Internal value (from version 05.00)
0x282B:003
(P125.03)
Inverter diagnoscs: Keypad LCD status
(Inverter diag.: Keypad LCD stat.)
•
Read only
Bit-coded state of the keypad status displays.
Bit 0 LOC 1 ≡ local keypad control acve.
Bit 1 REM 1 ≡ remote control via terminals, network, etc. acve.
Bit 2 MAN 1 ≡ manual setpoint selecon via keypad acve.
Bit 3 Auto 1 ≡ automac setpoint selecon via terminals, network, etc. acve.
Bit 4 Set 1 ≡ a parameter seng has been changed but not been saved yet in the
memory module with mains failure protecon.
0x282B:004
(P125.04)
Inverter diagnoscs: Acve drive mode
(Inverter diag.: Drive mode)
•
Read only
Display of the acve drive mode.
0 Velocity mode "Velocity mode" acve.
1 PID control PID control acve.
2 Torque mode (from version 03.00) "Torque mode" acve.
4 Jog operaon "Jog foward (CW)" or "Jog reverse (CCW)" funcon acve.
Diagnoscs and fault eliminaon
Diagnosc parameters
Inverter diagnoscs
602