214733 113 Revision A
Filling the Diesel Exhaust Fluid (DEF) Tank
The symbol inside the DEF gauge on the Harvest Performance Tracker display will signal the Operator when DEF level
is low.
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator’s seat for any reason.
Figure 4.8: DEF Tank
1. Stop the engine and remove the key.
2. Clean around filler cap (A).
3. Turn cap (A) counterclockwise until loose and remove cap.
NOTE:
Filler cap for DEF tank is blue and the nozzle dispenser is
smaller than that of the fuel tank.
CAUTION
Avoid contact with eyes. In case of contact, rinse immediately with water for 15 minutes.
Figure 4.9: DEF Tank
4. Fill tank with approved DEF. Refer to 5.1.3 Lubricants,
Fluids, and System Capacities, page 249.
IMPORTANT:
DEF is corrosive. Spilled DEF must be contained and
absorbed by non-combustible absorbent material like sand,
and then shovelled to a suitable container for disposal. If
spilled on tank or any surface of the vehicle, rinse
thoroughly with water.
IMPORTANT:
If the windrower temperature is going to be below 0°C
(32°F), do NOT fill the DEF tank more than 75% full. When
freezing, the DEF fluid will expand by approximately 7%. For
storage information, refer to 5.1.1 Storing Lubricants and
Fluids, page 247.
5. Replace filler cap (A) and turn clockwise until tight.
OPERATION
To Next Page
Loading...
