MacDon M1170 - Adjusting Draper Alarm Pressure

214733 213 Revision A
1019620
A
Figure 4.225: Draper Header Draper Page
4. Turn scroll knob to mode window (A) and select it.
5. Scroll in the pop-up window to MANUAL and select it.
1014968
A
B
Figure 4.226: Operator’s Console Draper Controls
6. Set draper speed with console controls as follows:
a. Press and quickly release DRAPER SPEED switch (A) to
increase draper speed in 0.2 km/h (0.1 mph) intervals.
b. Press and hold DRAPER SPEED switch (A) to increase
draper speed in 2 km/h (1 mph) intervals.
c. Similarly decrease draper speed with switch (B).
Adjusting Draper Alarm Pressure
Adjusting the draper alarm allows the operator to set an alert to inform them that the draper is operating at a desired
pressure. A lower setting will cause the alarm to be set off more often; a higher setting will allow the alarm to be set off
less frequently. This adjustment requires the header to be in operation.
1019554
A
Figure 4.227: Header Run Screen 1
1. If RUN SCREEN 1 is not already displayed, press soft key
1 (A) on the Harvest Performance Tracker (HPT) to display
draper RUN SCREEN 1.
OPERATION