214733 95 Revision A
• Manual (not auto) reel speed mode
• Manual (not auto) draper speed mode
• All functions unlocked
• All sensors enabled
• Cut width
• Swath roller selection off
• Max header raise/lower rates
• One-touch-return presets (reset to default option available also within this menu)
• DWA speed
• DWA alarm pressure
6. Press the HOME or BACK button. The CONFIRM YES/NO dialog box is displayed.
7. Select YES to save changes and close the dialog box, or select NO to close the dialog box without saving changes.
3.17.4 Calibrating the Windrower and Header
When a header is attached to the windrower, the Harvest Performance Tracker (HPT) will recognize the header ID and
determine the appropriate systems to calibrate. The following sensors may require calibration depending on header type:
• Header height
• Header angle
• Header float left
• Header float right
• Reel height
• Reel fore-aft
• Swath compressor
Recalibration is required if the HPT is replaced, a position sensor is replaced, sensor readouts are erratic, or the first time a
certain header type and attachment are connected to the windrower.
NOTE:
To calibrate the knife drive, the header must be attached and engaged. If the header is disengaged when calibration is
selected, the message ENGAGE HEADER will appear on the screen.
CAUTION
Before starting the machine, check to be sure all bystanders have cleared the area.
OPERATOR’S STATION
To Next Page
Loading...
