MacDon M1170 - Adjusting Knife Alarm Pressure - Draper Header

214733 219 Revision A
Adjusting Knife Alarm Pressure – Draper Header
Adjusting the knife alarm allows the operator to set an alert to inform them that the knife is operating at a desired
pressure. A lower setting will cause the alarm to be set off more often; a higher setting will allow the alarm to be set off
less frequently. This adjustment requires the header to be in operation.
1019554
A
Figure 4.236: Header Run Screen 1
1. If RUN SCREEN 1 is not already displayed, press soft key
1 (A) on the Harvest Performance Tracker (HPT) to display
draper RUN SCREEN 1.
1014578
A
B
Figure 4.237: HPT Scroll Knob and GSL Select Button
2. Press the scroll knob (A) on the HPT, or the SELECT
button (B) on the ground speed lever (GSL) to display the
QuickMenu page.
1019621
A
Figure 4.238: Draper Header QuickMenu
3. Turn knob to scroll to the KNIFE setting (A) on the
QuickMenu page, and press knob to select it.
OPERATION