214733 118 Revision A
Engine Start Troubleshooting Tips
If the windrower will not start normally, refer to the following troubleshooting table:
IMPORTANT:
Do NOT tow machine to start engine. Damage to hydrostatic drives will result.
Table 4.1 Engine Start Troubleshooting
Problem Solution
Controls not in NEUTRAL
• Move GSL to NEUTRAL
• Move steering wheel to locked (centered) position
• Disengage HEADER switch
Operator’s station not locked
• Adjust position of operator’s station
• Ensure lock is engaged
Neutral interlock misadjusted
• Contact MacDon Dealer
No fuel to engine
• Fill empty fuel tank
• Replace clogged filter
• Check for blocked or damaged fuel lines
Old fuel in tank
• Drain tank
• Refill with fresh fuel
Water, dirt, or air in fuel system
• Drain, flush, fill, and prime system
Improper type of fuel
• Drain tank
• Refill with correct fuel
Crankcase oil too heavy
• Replace with recommended oil
Low battery output
• Test the battery
• Check battery electrolyte level
Poor battery connection
• Clean and tighten loose connections
Faulty starter
• Contact MacDon Dealer
Wiring shorted, circuit breaker open
• Check continuity of wiring and breaker (manually reset)
Faulty injectors
• Contact MacDon Dealer
OPERATION
To Next Page
