MacDon M155 - Cab Display Module (CDM) Programming

OPERATOR’S STATION
3.19.5 Cab Dis
play Module (CDM) Programming
Figure 3.69: CDM
A-SideDisplay
B-MainD
isplay
C - Select Switch
D - Menu Item Scroll Fo rward E - Menu I tem Scroll Backward F - Program Switch
Side Display: Displays software revision status.
• Upper Line – C### (CDM)
• Lower Line – M### (WCM)
Main Display: Displays menu item and selection
13
.
• Upper Line – Menu Item
• Lower Line – Selection
Select Switch: Places monitor into Program Mode with program switch. Press to accept menu item and advance
to next item.
Menu Item Scroll Forward: Displays value under menu item.
• Push to scroll forward
• Hold down for fast scroll
14
Menu Item Scroll Backward: Displays value under menu item.
• Push to scroll backward
• Hold down for fast scroll
14
Program Switch: P laces monitor into program mode. Press while pressing select switch.
13. The current selection is flashing.
14. Fast scroll applies only when changing KNIFE SPEED, OVERLOAD PRESSURE, and TIRE SIZE.
147649 89 Revision A