MacDon M155 - Switching the Installed Header Sensors on or off

OPERATOR’S STATION
10. Press right (C) arro w to select YES. Press
SELECT (D).
11. Press and left (B) or right (C) arrow to cycle through the
last 10 recorded engine error codes until EXIT ENGINE
CODES is displayed.
• Refer to 8.4 Engine Error Codes, p age 46 9.
12. Press right (C) arro w to select YES. Press
SELECT (D).
13. Press PROGRAM (A) to exit Programming
Mode or press SELECT (D) to proceed to next
DIAGNOSTIC MODE.
Figure3.161:M155EngineCodes
Switching t he Installed Header Sensors On or Off
You can sel
ectively enable or disable header sensors in the event of a malfunction or as part of a
troublesh
ooting routine.
NOTE:
• The header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to 4.5 Attaching and
Detaching Headers, page 213.
• Disabled sensors flash the word SENSOR on CDM during regular operation.
1. Turn ignition key to RUN , or start the eng ine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line .
3. Press S ELECT (C) until DIAGNOSTIC MODE? is
displayed on the upper line.
• NO/YES is displayed on the lower line .
4. Press right (B) arrow to select Yes. Press SELECT (C).
• VIEW ERR OR CODES? is displayed on the
upper line.
Figu
re 3.162: M155 CDM Programming Buttons
147649 131 Revision A