OPERATOR’S STATION
4. Press SELECT (D) until DISC B LK INSTA LLED? is
displayed on the upper line.
• NO/YES is displayed on the lower line .
5. Press right (C) arrow to select YES. Press
SELECT (D).
6. Press P ROGRAM (A ) to exit Prog r am ming Mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.
Figure 3.10
0: Rotary Disc Hydraulics
Setting th
e Knife Overload Speed
NOTE:
• The header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to 4.5 Attaching and
Detaching Headers, page 213.
• The recommended knife overload speed is 75% of knife speed.
1. Turn ignition key to RUN , or start the eng ine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line .
3. Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed.
Figu
re 3.101: M155 CDM Programming Buttons
147649 103 Revision A
To Next Page
Loading...
