MacDon M155 - Operating with an A-Series Header; Auger Speed; Auger Speed on A30-D Headers; Setting the Auger Speed on A40-D Headers

OPERATION
4.7 Operating with an A-Series Header
The M155 is factory-equipped to run an A-Series Auger Header.
4.7.1 Auger Speed
Auger Speed on A30-D Headers
On A30-D Auger Headers, the auger speed is fixed to the knife speed. The auger speed is NOT monitored
and cannot be displayed.
Setting the Auger Speed on A40-D Headers
Figure 4.296: Operator Console
CAUTION
Check to be sure all bystanders have cleared the area.
To set the auger speed, follow these s teps:
1. Engage header.
2. Set the HEADER INDEX s witch (B) to OFF.
3. Press DISPLAY SELECTOR switch (E) on the ground speed lever (GSL) or press FAST (C) or SLOW (D) on
the cab display module (CDM) until ##.# A UGER SPEED is displayed a t (A).
The displayed value (##.#) = auger speed setting.
147649 294 Revision A