MacDon M155 - Exhaust System

MAINTENANCE AND SERVICING
2. Add lubricant as follows:
a. Remove breather cap (A) and add lubricant
until it runs out t he che c k port. If refilling, add
approximately 2.2 US quarts (2.1 liters).
b. Replace check plug and breather cap and tighten.
c. Operate the engine at low idle and check for leaks
at the check plug and drain plug.
Figure 5.109: G earbox Breather Cap
Changing Lubricant
Change gea
rbox lubricant after the first 50 hours, and the n at 500 hours as follows:
NOTE:
The engine should be warm prior to changing the oil.
1. Stop engi
ne and remove key.
2. Place a 1 U
S gallon (4 liters) drain pan under the gearbox.
3. Remove dr
ain plug (B) and allow oil to com pletely
finish dr
aining.
4. Install
drain plug (B) an d r emove check plug (A).
5. Add lubr
icant. Refer to Checking Lubricant Level and
Adding L
ubricant, page 363.
6. Operat
e the engine at low idle and check for leaks at
the che
ck plug and drain plug.
Figure 5.110: Gearbox Lubricant Drain Plug
Exhaust System
CAUTION
Engine exhaust stack may be hot. To avoid burns, do NOT touch exhaust canister when engine is running.
Allow sufficient cooling time after shut-down.
147649 364 Revision A