MacDon M155 - Setting the Rotary Disc Overload Speed

OPERATOR’S STATION
4. Press SELECT (D) until KNIFE OV ERLOA D SPD? is
displayed on the upper line.
• Current overload speed is displayed on the
lower line .
NOTE:
Default setting is -300 SPM. Ra n ge is -500 to
-100 SPM.
5. Press left (B) or right (C) arrows to set knife overload
speed. Press SELECT (D).
6. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D ) to proceed to next WINDROWER
SETUP action.
Figure 3.10
2: M155 Knife Overload Speed
Setting th
e Rotary Disc Ove rload Speed
NOTE:
• The header MUST be attach ed to the windrower to perform this proce du re. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to 4.5 Attaching and
Detaching Headers, page 213.
• The recommended disc overload speed is 75% of disc speed. For more information refer to the rotary disc
header operator ’s manual to determine proper overload speed.
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
NO/YES is displayed on the lower line.
3. Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed.
Figu
re 3.103: M155 CDM Programming Buttons
147649 104 Revision A