MAINTENANCE AND SERVICING
Changing Hydraulic Oil Filters
The charge filter (A) and return filter (B) are located ju s t
inside the frame on the left side and are accessible from
under the windrower. C hange as follows:
NOTE:
Change hydraulic oil filter s after the first 50 hours o f
operation, and every 500 hours thereafter. Filter (A)
(MD #112419) and filter (B) (MD #151975) can be
obtained from your Dealer.
Figure 5.188: Hydraulic Oil Filters
Charge Filter
The charge filter filters the oil in the windrower hydraulic charge circuit that supplies make up oil for normal losses
at motor and pump case drains and associated circuits.
Refer to the following procedures to change the charge filter:
• Rem oving Charge Filter, page 404
• Installing Charge Filter, pa ge 405
Removing Charge Filter
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove
the key from the ignition before leaving the operator’s seat for any reason.
1. Stop the engine and remove the key.
2. Clean around head of the filter.
3. Place a container beneath the filter to collect an y oil
that may leak out.
4. Unscrew filter (A) with a filter wrench.
5. Disposeofusedoilandfilter in accord ance with local
environmental legislation.
Figure 5.189: Hydraul ic System
147649 404 Revision A
To Next Page
Loading...
