MacDon M155 - Adjusting the Cab Display Backlighting

OPERATOR’S STATION
3. Press SELECT (B) until CAB DISPLAY SETUP? is
displayed on the upper line.
• NO/YES is displayed on the lower line .
4. Press right (A) arrow to select YES. Press SELECT (B).
• DISPLAY LANGUAGE? is displayed on the
upper line.
Figure 3.77
: M155 Cab Display Setup
5. Press SELECT (D) until BUZZER VOLUME is
displayed on the upper line.
• Previous setting is displa ye d on the lo we r lin e.
6. Press left (B) or right (C) arrows to adjust
buzzer volume.
7. Press P ROGRAM (A ) to exit Prog r am ming Mode or
press SELECT (D) to proceed to next CAB DISPLAY
SETUP? action.
Figure 3.78: M155 Buzzer Volume
Adjusting the Cab Display Backlighting
The backlighting feature brightens the display screen helping you read the cab display module (CDM) in low
light situations.
1. Turn ignition key to RUN , or start the eng ine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line .
Fig
ure 3.79: M155 CDM Programming Buttons
147649 93 Revision A