OPERATOR’S STATION
4. Press SELECT (D) until HEADER INDEX MODE ? is
displayed on the upper line.
• REEL & CONVE YOR or REEL ONLY is displayed
on the lower line.
5. Press left (B) or right (C) arrows to set header index
mode. Press SELECT (D).
6. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D ) to proceed to next WINDROWER
SETUP action.
Figure 3.11
0: M155 Header Index Mode
Setting th
eReturntoCutMode
For more information on the Return to Cut feature, refer to 4.4.7 Return to Cut , page 207.
NOTE:
The header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For m ore information, refer to 4.5Attachingand
Detaching Headers, page 213.
1. Turn ign
ition key to RUN, or start the engine.
2. Press PR
OGRAM (A) and SELECT (C) on cab display
module (
CDM) to enter Programming Mode.
• WINDRO
WER SETUP? is displayed on the
upper l
ine.
•NO/YES
is displaye d on the lower line.
3. Press r
ight (B) arrow to select YES. Press SELECT (C).
• SET KN
IFE SPEED? is displayed.
Figure 3.111: M155 CDM Programming Buttons
147649 108 Revision A
To Next Page
Loading...
