OPERATION
11. Install clevis pin (A) through boot and foot and secure
with hairpin (B). Repeat for opposite side.
IMPORTANT:
Ensure clevis pin (A) is fully inserted and ha irp in
is installed behind bracke t.
Figure 4.254: Header Boot
12. Remove clevis pin fro m storage position (B) in linkage
and insert into hole (A) to engage float springs. Secure
with hairpin.
Figure 4.255: Header Float Linkage
13. Disengage safety prop by turning lever (A) downwards
to re lease an d lower s top until lever locks into
vertical position.
14. Repeat for opposite safety prop.
Figure 4.256: Safety Prop
147649 270 Revision A
To Next Page
Loading...
