MAINTENANCE AND S ERVICING
1. Screw the new secondary filter (A) onto the filter mount
until the gasket contacts the filter head.
2. Tighten the filter an additional 1/2 to 3/4 turn by hand.
IMPORTAN T:
Do NOT use a filter wrench to install the filter.
Overtightening can damage the gasket and filter.
Figure 5.79: Fuel System
3. Open fuel valve (A) under fuel tank.
4. Prime the fuel system. Refer to Priming Fuel System,
page 352.
Figure 5.80: Bottom of Fuel Tank
Draining Fuel Tank
Draini
ng the fuel tank is necessary to remove old or contaminated fuel.
WARNING
• To avoid personal injury or death from explosion or fire, do NOT smoke or allow flame or sparks near
fuel tank when refueling.
• NEVER refuel the windrower when the engine is hot or running.
DANGER
To avoid
bodily injury or death from unexpected startup of the machine, always stop the engine and remove
the key
from the ignition before leaving the operator’s seat for any reason.
1. Stop the engine and remove the key.
2. Open the hood., Refer to 5.2.1 Opening Hood (Lower
Position), page 306.
147649 349 Revision A
To Next Page
Loading...
