MacDon M155 - Page 502

INDEX
hay conditioner ............................................ 112
header cut width ......................................... 109
header index mode ..................................... 107
hydraulic center-link .................................... 101
hydraulic overload pressure......................... 106
knife overload speed ................................... 103
knife speed ................................................. 105
return to cut mode....................................... 108
rotary disc hydraulics................................... 102
rotary disc overload speed........................... 104
tire size .......................................................114
troubleshooting
activating hydraulic purge ............................ 142
forcing a Header ID..................................... 134
header sensors........................................... 131
sensor input signals .................................... 132
testing double windrow er attachment
(DWA) ...................................................... 151
testing draper drive ..................................... 146
testing header tilt ........................................ 139
testing header up/down ............................... 135
testing knife drive........................................ 144
testing reel drive ......................................... 147
testing reel fore-aft ...................................... 140
testing reel up/down function ....................... 137
testing rotary disc drive................................ 149
windrower error codes
engine error codes ................................... 129
warning/alarms................................................. 85
cab temperature, See H VAC sy stem
California proposition 65......................................... 2
CanWin
cab display module (CDM)
error codes ................................................. 481
CanWin service too l
cab display module (CDM)
clearing sub-acres........................................116
caster wheel, See wheels and tires
CDM, See cab display module (CDM)
center-links ......................................................... 29
See also hydraulic links
See also mechanical links
definitions ........................................................ 29
self-locking center-link hook mechanism .......... 205
circuit breakers
accessing ...................................................... 396
replacing ........................................................ 397
climate control system, See HVAC system
climate controls ................................................... 57
component locations ............................................ 36
consoles ............................................................. 39
conversion charts .............................................. 468
cutting height..................................................... 206
D
D-Series headers
attaching........................................................ 213
header boots ....................................... 213, 280
deck shift ....................................................... 291
setting float options ..................................... 291
definitions ........................................................ 29
draper index
setting draper index..................................... 287
draper speed.................................................. 286
setting draper speed ................................... 286
setting independent of ground speed ............ 288
setting minimum draper speed ..................... 286
header float
float options with deck shift.......................... 291
header position .............................................. 281
hydraulics configuration - D-Series .................. 279
knife speed
setting knife speed “on the go” ..................... 290
reel fore-aft position........................................ 281
reel height...................................................... 282
reel speed ...................................................... 282
reel index ................................................... 282
reel minimum speed.................................... 282
reel only speed ........................................... 285
reel to ground speed ................................... 282
setting draper to ground speed........................ 286
decals
fuse box decal................................................ 398
GSL header switch functions ............................. 69
location of safety signs ..................................... 13
deck shift - D-Series .......................................... 291
declaration of conformity ......................................... i
definition of terms ................................................ 29
double windrow attachment (DWA) ......................211
deck position................................................... 211
draper speed.................................................. 212
draper index
setting for D-Series......................................... 287
draper speed
setting for D-Series......................................... 286
setting independent of ground speed ............... 288
setting minimum draper speed ........................ 286
drive wheels
installing ........................................................ 417
driving the windrower ......................................... 165
cab-forward operation..................................... 168
driving on road ............................................... 175
engine-forward operation ................................ 170
entering/exiting............................................... 167
reverse in cab-forward mode........................... 169
reverse in engine-forward mode ...................... 171
spin turn ........................................................ 172
stopping......................................................... 172