NEC Univerge SV9100 - Page 1300

1300
Program
Number
Program Name/Description
Input Data
Default
15-02-02
Multiline Telephone Basic Data Setup –
Trunk Ring Tone
Set the tone (pitch) of the incoming trunk ring
for the extension port you are programming.
1 = High
2 = Medium
3 = Low
4 = Ring Tone 1
5 = Ring Tone 2
6 = Ring Tone 3
7 = Ring Tone 4
8 = Ring Tone 5
2
15-02-03
Multiline Telephone Basic Data Setup –
Extension Ring Tone
Set the tone (pitch) of the incoming extension
call ring for the extension port you are
programming. Also refer to Program 15-08.
1 = High
2 = Medium
3 = Low
4 = Ring Tone 1
5 = Ring Tone 2
6 = Ring Tone 3
7 = Ring Tone 4
8 = Ring Tone 5
8
15-02-21
Multiline Telephone Basic Data Setup –
Virtual Extension Access Mode (when idle
Virtual Extension key pressed)
Determine whether an extension Virtual
Extension Key should be used as a DSS key to
the extension and for receiving calls (0),
answering incoming calls and ability to place
outgoing ICM or CO calls (1), or just receiving
incoming calls (2). If the key is used for
outgoing calls, the extension number of the key
must be a real extension or virtual extension
number. When the extension number of the
key is a real extension number, and the key is
pressed, the real extension cannot be used.
Virtual Extension Key Mode
0 = DSS
1 = OTG (Outgoing)
2 = Ignore
2
15-02-30
Multiline Telephone Basic Data Setup – Toll
Restriction Class
Assign if the phone uses the Toll Restriction
class of the VE (0) or the Real Extension when
making outbound calls from the VE.
0 = Vir. Ext. (Virtual Extension
Class)
1 = Real Ext. (Real Extension
Class)
1
15-07-01
Programmable Function Keys
Assign Virtual Extension function keys on
Multiline telephones (code *03 + extension
number).
Line Key 1 ~ 48
0 ~ 99 (Normal Function Code
851 by default)
*
00 ~
*
99 (Appearance
Function Code) (Service Code
852 by default)
15-08-01
Incoming Virtual Extension Ring Tone Setup
When an extension or a virtual extension is
assigned to the function key on the key
telephone, select the ring tone when receiving a
call on that key.
For CAR keys, only tone pattern 1 can be
used. The remaining patterns are not checked
with this feature.
0 = Tone Pattern 1
1 = Tone Pattern 2
2 = Tone Pattern 3
3 = Tone Pattern 4
4 = Incoming Ring Tone
Extension
5 = Tone Pattern 5
6 = Tone Pattern 6
7 = Tone Pattern 7
8 = Tone Pattern 8
0
15-09-01
Virtual Extension Ring Assignment
Individually program an extension Virtual
Extension key(s) to either Ring or Not Ring.
Day Night/Mode: 1 ~ 8
Ringing:
0 = Not Ring
1 = Ring
0