275
ACI Delay Announcement – 2nd Delay
Announcement Sending Duration
Set the time the 2nd Delay Announcement
plays. After this time expires, the call
disconnects. To keep the call in queue, set this
time to 0.
VRS Delay Announcement – Delay Message
Start Timer
Set the time before the 1st Delay Message
Starts.
VRS Delay Announcement – 1st Delay
Message Number
Assign the VRS message number to be used
as the message source for the 1st and 2nd
Delay Announcement Messages. Refer to
Program 41-08 for more on setting up the
overflow options. This program is activated
when the delay announcement source and
options are assigned as VRS in Program
41-08-03.
0 ~ 101
0 = No Message
101 = Fixed Message
VRS Delay Announcement – 1st Delay
Message Sending Count
Input the number of times the 1st Delay
Message is sent. If set to 0, the message is not
played.
VRS Delay Announcement – 2nd Delay
Message Number
Input the VRS Message to be played as the 2nd
Delay Message.
0 ~ 101
0 = No Message
101 = Fixed Message
VRS Delay Announcement – 2nd Waiting
Message Sending Count
Input the number of times the 2nd Delay
Message is sent. If set to 0, the message is not
played.
VRS Delay Announcement – Tone Kind at
Message Interval
Input what is heard between the Delay
messages.
0 = Ring Back Tone
1 = MOH Tone
2 = BGM Source
VRS Delay Announcement – Forced
Disconnect Time after the 2nd Delay
Message
Set the time, after the last 2nd Delay Message
is played, before the call is disconnected.
0 ~ 64800 seconds
(0 = No Disconnect)
VRS Delay Announcement – Queue Depth
Announcement (Requires VRS)
Input when the Queue Depth Announcement
will be played.
0 = Disable
1 = After 1st (1st)
2 = After 2nd (2nd)
3 = After 1st and 2nd (1st and
2nd)
Night Announcement Setup – Night
Announcement Source Type
Define the source for each groups night
announcement. Night announcement
availability depends on the setting in Program
41-03-02.
To Next Page
Loading...
