883
If Flexible ringing is set, the Callback to Cell Phone feature works in any type of Program
22-02-01 trunk setting. If Flexible ringing is not set, the Callback to Cell Phone feature does
not work if the incoming call type is “DID/DISA”.
After answering Callback, if the system does not receive a DTMF signal from the Mobile
Extension using Program 20-18-01 (Default; 30 seconds), the system disconnects the call.
The trunk user for SMDR for Callback is tied to the extension number of Mobile Extension.
If the user calls a Mobile Extension port during while using the Callback to Cell Phone
feature, the caller hears a busy tone.
The Callback to Cell Phone feature can be used on the K-CCIS network. Netlink can be
used for the Callback line, but not for the incoming line.
Default Settings
No Mobile Extensions are configured.
System Availability
Terminals
All Multiline Terminals
Required Component(s)
None
Related Features
Caller ID
Call Forwarding
Direct Inward Dialing (DID)
Direct Inward Line (DIL)
Speed Dial – System/Group/Station
Station Message Detail Recording
To Next Page
Loading...
