886 
 
System Options for Single Line Telephones 
– Dial Sending Start Time for SLT or ARS 
When an extension user dials a Mobile
 
Extension number, the system waits this time
 
before dialing the number. 
Class of Service (Incoming Call Service) –
 
Caller ID Display 
Turns Off or On  the Caller ID display at an
 
extension. 
ISDN Calling Party Number Setup for Trunks 
Assign Calling Party Numbers for each trunk
 
(maximum 16 digits per entry). When a call is
 
made by an extension which does not have an
 
Extension Calling Number assigned (Program
 
21-13), the system sends the calling number for
 
the ISDN trunk defined in 21-12. If the Calling
 
Party Number is assigned in both Program 
21-12 and Program 21-13, the system sends
 
the data in Program 21-13. 
Maximum of 16 digits.
 
(1-0, *, #) 
ISDN Calling Party Number Setup for
 
Extensions 
Assign each extension a Calling Party Number
 
(maximum 16 digits per entry). The calling
 
number is the subscriber number of the dial-in
 
number. When a call is made by an extension
 
which does not have an Extension Calling
 
Number assigned (Program 21-12), the system
 
sends the calling number for the ISDN trunk
 
defined in Program 21-13. If a Calling Party
 
Number is assigned in both Program 21-12 and
 
Program 21-13, the system sends the data in
 
Program 21-13. 
Maximum of 16 digits.
 
(0 ~ 9, *, #) 
System Options for Incoming Calls – Mobile
 
Extension Answer Time 
Determines the amount of time before the
 
mobile extension will answer with internal dial
 
tone.  Extend this timer long enough for 1 ring
 
cycle to complete, giving the mobile extension
 
user time to hang up and wait for callback. 
DID Translation Number Conversion –
 
Received Number 
Define the digits received by the system for the
 
telephone number on which a Mobile Extension
 
user calls into the system. 
DID Translation Number Conversion –
 
Target Number 
For the DID number defined in Program 
22-11-01, enter the extension number for the
 
Mobile Extension user.