RFL Electronics GARD 8000 - Page 336

Chassis Configuration Settings
GARD 8000 SYS RFL Electronics
April 1, 2012 7-100 973.334.3100
The following files appear as choices in the “Send file to GARD 8000” pulldown menu.
Whole Chassis Configuration
This file contains all the settings for a complete chassis. It can be loaded from a PC to configure the
GARD unit in one step.
System Logic Database (.TXT File)
This file defines the web pages that configure the system logic. It must be loaded prior to a new logic
(.EDN) loading.
System Logic (.EDN File)
This file contains the actual system logic.
System Logic DSN (.DSN file)
This file is the ORCAD source file that is needed to edit the logic. It is not used by the GARD, merely
stored on it so that it can be uploaded and editing of the logic can be done.
System Logic PDF (.PDF File)
This file is a printable copy of the logic schematic created from the ORCAD source file. It is not used
by the GARD, merely stored on it so that it can be uploaded and printed.
Chassis Drawing (.PDF File)
This file contains GARD layout and application drawings specific to each customer.
System Logic Configuration (.ZIP file)
This file contains the following files in a Zip format:
System Logic Database (.TXT File)
System Logic (.EDN File)
System Logic DSN (.DSN File)
System Logic PDF (.PDF File)
System Logic Firmware (.HEX File)
This is the operating software for the logic processor. This file is only loaded when there is a system
upgrade.
Distance Relay Module Settings Database
This file defines the pages for the distance relay settings. It needs to be loaded only when the distance
relay module is updated.
Distance Relay Module SOE Database
This file defines the pages for the distance SOE settings. It needs to be loaded only when the distance
relay module is updated.
Distance Relay Module Fault Record Database
This file defines the pages for the distance fault record settings. It needs to be loaded only when the
distance relay module is updated.
Distance Relay Module Logic Configuration
This file defines the distance relay internal logic. It needs to be loaded only when the distance relay
module logic is updated.