1001 Bit Switch
011 Bit Switch B 0 1
bit 0
to 1
DFU - -
bit 2
Switch for enabling or disabling Limitless Paper
Feeding for the Bypass Tray
0: Enable 1: Disable
When the Bypass Tray is the target of the Auto Tray Select and Any Size/Type is
configured for the Tray Setting Priority setting of the Bypass Tray, this BitSwitch can
switch the behavior whether or not Limitless Paper Feeding is applied to the Bypass
Tray.* The default is Enabled (=0).
*Limitless Paper Feeding will try a matching tray of the next highest priority if a job
specified to Auto Tray Select as the tray setting is submitted and the tray runs out of
paper.
Enabled (=0: Default):
Limitless Paper Feeding is applied to the Bypass Tray.
If a tray other than the Bypass Tray matches the job's paper size and type but has
run out of paper, printing will occur from the Bypass Tray.
Disabled (=1):
Limitless Paper Feeding is not applied to the Bypass Tray.
If a tray other than the Bypass Tray matches the job's paper size and type but has
run out of paper, printing will stop and an alert will appear on the LCD screen,
stating that the tray has run out of paper. This prevents unexpected use of the Bypass
Tray.
Limitations when this BitSwitch is set to "1":
- The "Paper Tray Priority: Printer" setting must be configured to a tray other than the
Bypass Tray.
- Jobs that contain more than one paper size cannot be printed.
Printer Service Mode
253
To Next Page
Loading...
