pcodes.fm
P31003-H3550-S403-4-7620, 02/05
HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual
A-19
System Programming Codes (Expert Mode Codes)
22 39 1 IP interface, mode:
0 = inactive
1 = HIP Forwarding
2 = LIM
3 = SLIP Routing
22 39 2 IP address, data (7 ... 15): x.x.x.x (x = 0 ... 255)
Use either "*" or "." as a separator.
22 39 3 Subnet mask
22 39 4 Gateway IP address
22 40 Open numbering scheme
22 40 1 Active/inactive
22 40 2 Voice mail node number
22 40 3 Node number
22 41 UCD permanently available: 0 = inactive, 1 = active
23 Code
23 1 Substitute code *, code 75
23 2 Substitute code #, code 76
23 3 Trunk access code; select slot and trunk and enter new code
23 4 Route code; Select route followed by position 1-10 for code and enter
new code
Route 1-8 (HiPath 3350HiPath 3300,)
Route 1-16 (HiPath 3750, HiPath 3550, HiPath 3700, HiPath 3500)
23 5 Attendant code
23 5 1 Attendant code DID
23 5 2 Attendant code internal
23 6 Second trunk access code
23 7 Reset telephone lock code
23 8 Hotel terminal
24 Door relay
24 1 Entrance phone; select door, max. 6 digits, door 1-4
24 2 Destination; select door, max. 6 digits, door 1-4
24 3 Door opener, select door: 0 = not available, 1 = available, 2 = available
with DTMF, doors 1-4
Table A-3 Expert Mode Codes
Code Function
To Next Page
Loading...
Need help?
General