Trimble TMX-2050 - Select an implement; Edit an implement; Delete an implement

Implement setup 8 Implements
1. Select an operation type, make, model and name the implement. (See Implement setup, 188.)
2.
At any point after you complete the NAME section, tap SUMMARY, then tap .
Select an implement
Note – You can only enter the Run screen with an implement when the required implement setup
and calibration steps are complete. When you change implements, make sure that all related
configurations are accurate for the current operation.
To select an implement that is already set up:
1.
Tap at the Home screen.
2.
To select an implement in the list, tap the implement.
3.
Tap Select. The name of the implement highlights in blue and a displays next to the name.
Note – Without a blue highlight, the indicates an implement that was selected previously.
Edit an implement
1.
Tap on the Home screen.The Implement setup panel displays.
2. In the list of implements, tap the implement that you want to edit.
3. Tap Edit.
4. Tap the section where you want to make edits.
5.
When you are finished, tap Summary at the top right corner of the screen. For details, see
Review implement summary, 222.
If any part of the setup is Not Complete, you can save the changes but you cannot use the
implement on the Run screen.
6.
To save your changes to the implement, tap . The Home screen displays.
7.
Todiscard your edits and not change the existing profile, tap . The display returns you
to the Implement setup panel.
Delete an implement
You can delete an implement. However, when you do so, all settings associated with that
implement will also be deleted.
Version 1.075, Revision C TMX-2050 Display User Guide 189