Trimble TMX-2050 - Modules

Application control 8 Implements
3.
If you use Field-IQfor section control, tap each setting and choose an option.
Tap... Tap to...
Number of Modules Enter the number of Section Control modules you have installed. The
maximum number of Section Control modules is 4.
Section Control Type Select the type of section control hardware you have installed:
ll Boom Valve : The section control module sends power to the
section valve to turn on the clutch off.
l Tru Count Liquid-Block Valve™ : The section control module
sends power to the section valve to turn on the clutch on.
l Tru Count Air Clutch®: The section control module sends power
to the section valve to turn on the clutch on.
l Tru Count Section Electric Clutch: The section control module
sends power to the section valve to turn on the clutch off.
Fence Row Nozzle Identify the location of fence row nozzles on the implement, if any:
ll None (Default)
l Left Only
l Right Only
l Both
Note – The display only controls the fence row if the sprayer
configuration allows it. Refer to the Field-IQ installation guide for
additional information.
Right Nozzle Wiring
Select the wiring option used during installation:
ll If you are using an EZ-Boom® or Raven replacement harness,
select the EZ-Boom setting.
l Otherwise, choose the Field-IQ option.
4. Tap Next to continue to Modules, 199.
Modules
1.
At the Modules section for Section Control, tap the box for the module and complete the
following settings.
Version 1.075, Revision C TMX-2050 Display User Guide 199