10 Operations Guidance patterns
17. Tap Exit to closes the Field Manager.
18. Verify that the shifted infills are now shown and can be used for guidance.
Change the infill pattern
Note – This process assumes you have an existing headland and an infill pattern has been created.
1.
Select a vehicle, implement and field. (See Select a field, 182).
Note – The display uses the implement width to place the headland boundary, space the
circuits and project guidance lines for the pattern.
2.
Tap to enter the field.
If you need to create a new infill pattern to change to, go to step 3.
If you have an existing infill pattern you want to change to, go to step 4.
Note – If the system has been turned off, when you enter the field you will only see the
headland on the Run screen and not the infill pattern.
3.
At the Run screen, create a new guidance line to use as the infill pattern. (See AB guidance line
creation (Run screen), 251 or A+ guidance line creation (Run screen), 252).
Note – This new guidance line is automatically made active by the system, which deactivates
all other guidance patterns, including the headland you are working with.
4.
Open the Field Manager by tapping .
256 TMX-2050 Display User Guide Version 1.075, Revision C
To Next Page
Loading...
