Trimble TMX-2050 - Steering and guidance settings; Access

Steering and guidance settings 3 Display settings
Steering and guidance settings
The following settings enable you to customize controls related to steering and guidance.
Setting Tap to view or change...
Operator Timeout The amount of time before the display disengages auto guidance
and stop applications when there is no response to a shutdown
message.
Nudge Increment
The increment used to nudge the guidance system with each tap.
You can incrementally nudge a pattern in a perpendicular direction
relative to the pattern. Nudging a pattern helps adjust for satellite
drift.
See Guidance pattern adjustment (Run screen), 260 and GNSS and
xFill technology status, 315.
Implement DraftIncrement
The increment used to nudge the implement to the current
guidance line.
See Guidance pattern adjustment (Run screen), 260.
Aggressiveness Increment
The increment used to change aggressiveness.
See Steering adjustments, 244.
Autosteering Lockout Whether the feature is on or off. When lockout is on, the display
does not offer an option to use auto guidance.
Re-markReset with Import
Remove all re-mark entrees on with an import.
See Guidance pattern adjustment (Run screen), 260.
End of Row Distance
Distance for the end of row warning to display.
See End of row warning, 292.
NMEA from Autopilot
Diagnostics Port
On: NMEA messages can be sent from the NavController II
Off:No messages are sent
See NMEA messages, 298.
Access
To access the Steering and Guidance settings:
Version 1.075, Revision C TMX-2050 Display User Guide 85